Programming; Enter Programming In Basic Mode - Rae QRAE 3 User Manual

8. Programming

The menu in Programming Mode is to adjust settings, calibrate sensors, and initiate
communication with a computer. It has the following submenus:
 Calibration
 Measurement
 Alarms
 Datalog
 Monitor
 Wireless

8.1. Enter Programming In Basic Mode

1. To enter Programming Mode, press and hold [MODE] and [Y/+] until you see the Password
screen.
2. Input the 4-digit password:
 Increase the number from 0 through 9 by pressing [Y/+].
 Step from digit to digit using [MODE].
 After inputting the password's four digits, advance to "OK."
 Press [Y/+] to register the password and enter Programming Mode. Otherwise, advance to
"Cancel" then press "[Y/+].
If you make a mistake, you can cycle through the digits by pressing [MODE] and then using
[Y/+] to change the number in each position.
Note: The default password is 0000.
Note: The password screen only appears when you enter the Programming Mode the first time
after turning the instrument on in Basic Mode. If you have input the correct password, you do not
have to input it again to enter Programming Mode until you turn the instrument off and on again.
15