Table of Contents
Advertisement
6. PARAMETER SETTINGS
6.4 Setting Parameters with the Configuration Software (Parameter Setting Tool)
6.4.1
Setting configuration
This system gives an outline of the setting method using the configuration software. While the
following explanations are based on screens of SyCon Ver. 2.0.6.2, the screen hierarchy and
items of the setting are subject to change due to potential changes in the specifications of the
configuration software. Refer to the operation manual of the configuration software for the
latest information.
The following four steps are required to set the DN91 parameters:
1)
Set configuration
2)
Set master parameters
3)
Set bus parameters
4)
Set device (slave) parameters
Set the DeviceNet network configuration on the screen below.
−
6
3
MELSEC-A
Advertisement
Table of Contents
Troubleshooting
