DeWalt DXAEC80 Instruction Manual page 17

NOTES:
A. In Multi-Bank Mode, the maximum output current is
approximately 15A for each Bank.
B. If the selected battery is already charged to nearly full capacity,
the unit's output current may be automatically reduced by a
few amperes, despite the maximum output current rating of
15A.
C. The charging process will start automatically approximately
one minute after the clamps of either Bank are properly
connected to a battery if no other actions are taken.
D. The charging process can be terminated by pressing the
Battery Charge Button again to stop the function. The unit
will revert to the Standby Mode. It will automatically restart
the charging process after approximately one minute if no
other actions are taken.
E. In Charging Mode, the Digital Display shows the output
current (A) that is charging the selected battery by default.
Press the Battery Voltage Button once to show the voltage
(V) of the connected battery. Press the Battery Voltage
Button again to show the charge status of the battery as a
percentage (%) of full. Pressing the Voltage Button cycles
through different charging status views of the selected
battery.
F. Press and hold the Single/Multi-Bank Selection Button for
one second to cycle through to view a different Bank in
Multi-Bank Mode.
G. Press the Single/Multi-Bank Selection Button again to switch
the unit to Single-Bank Mode.
7. When the battery is completely charged, the corresponding Bank
automatically goes into Float Charge Mode. In this mode, the unit
monitors the battery voltage and charges as necessary to assure
DXAEC80_DXAEC80CA_ManualENFRSP_082616.indd 17
the selected battery maintains a full charge. The unit remains in
Float Charge Mode as long as the charger is connected to the
battery and plugged into a functioning AC outlet. For example,
if the Bank 1 channel is in Float Charge Mode, the backlit LCD
screen will display the following:
The selected charging Bank Indicator flashes. The Digital Display
shows "FLO" indicating that the unit is in Float Charge Mode. The
Clamp Icons and the Battery Icon (with three bars) will light solid.
NOTES:
A. In Float Charge Mode, the Digital Display shows "FLO" by
default. Press the Battery Voltage Button once to show the
voltage (V) of the selected battery. Press the Battery Voltage
Button again to show the charge status of the selected
battery as a percentage (%) of full. Pressing the Voltage
Button cycles through different charging status views of the
selected battery.
B. Press and hold the Single/Multi-Bank Selection Button for
one second to cycle through to view a different Bank in Multi-
Bank Mode.
C. Press the Single/Multi-Bank Selection Button again to switch
the unit to Single-Bank Mode.
8. When disconnecting the battery charger, unplug the AC Power
Cord, and then disconnect the battery charger from the battery (or
batteries) following the last step of the appropriate set of directions
in the "Preparing to Charge" section of this Instruction Manual.
17
10/19/2016 3:58:07 PM