AnyCubic i3 MEGA User Manual page 20

'tell' the machine Z axis is getting to zero and stop moving.
(3) Therefore, tighten Z adjustable nut by
X
( is defined by how much the nozzle is under the platform)
nozzle is too high from the platform
. It may need adjustment for few times.
platform)
Tighten or loosen it
(4) Click "Tools"--> "Home" --> "Home all" to verify the results. After this, please
level the platform again from Step 3.
Z adjustable nut
X
mm if nozzle is lower than the platform
Y
( is defined by how much the nozzle is above the
14
(Figure 13)
, while loosen it by
(Figure 14)
Y
mm if