Oregon ST275 Original Instruction Manual page 20

CHARGING THE BATTERY PACK
WARNING: FAILURE TO FOLLOW
PROPER CHARGING PROCEDURES
MAY CAUSE EXCESSIVE VOLTAGE,
EXCESSIVE CURRENT FLOW, LOSS
OF CONTROL DURING CHARGING,
LEAKAGE OF HAZARDOUS CHEMICALS,
HEAT GENERATION, BURSTING, OR
FIRE. FOLLOW THESE CHARGING
INSTRUCTIONS.
With the charger cord connected to the
charger and plugged into an electrical outlet,
align the grooves in the battery with the rails
on the charger and slide the battery pack onto
the charger until fully seated (Fig 7)
FIG 7
Check the charge-state indicator for charging
conditions
20
ST275_Operating_Manual_EU.indd 20
SAFETY RULES
INSERTING AND RELEASING
THE BATTERY PACK
Only use the Oregon® brand battery packs
specified in these operating instructions
Align the groove in the battery with the rails
inside the battery port Firmly insert the
battery pack into the trimmer/edger's battery
port, pressing forward until it clicks as it locks
into place (Fig 8)
FIG 8
To remove the battery pack, lift up on the
battery release, grasp the sides of the
battery pack, and remove it (Fig 9)
FIG 9
Oregon® Trimmer/Edger Model ST275-GSL
17/06/16 9:44 AM