Oregon ST275 Original Instruction Manual page 18

ATTACHING THE FRONT HANDLE
The front handle fits on the shaft at a
comfortable distance between the rear handle
and the trimmer motor housing (Fig 2)
• Grip the front handle near the clamping point
(1)
• Snap the front handle onto the shaft so that
the clamp is nearest the rear handle (2)
• Insert the front handle adjustment knob
through the hole on the front handle (3) and
tighten
FIG 2
18
ST275_Operating_Manual_EU.indd 18
SAFETY RULES
ATTACHING THE GUARD
The guard fits onto the slot on the trimmer
motor housing (Fig 3)
• Turn the trimmer/edger upside down
• Slide the guard onto the trimmer until it
• Tighten the screws on the housing (2) until
• Make sure that the line cutting blade (3)
IMPORTANT: INSTALL THE SCREWS TO
MAKE SURE THE GUARD STAYS IN PLACE
(1)
(3)
(2)
snaps into place (1)
fully seated to hold the guard in place
is attached to the guard to insure that the
trimmer/edger functions correctly
FIG 3
(3)
(1)
Oregon® Trimmer/Edger Model ST275-GSL
(2)
17/06/16 9:44 AM