Calling A Unit (Residential/Tenant Station) Or Guard Station - Aiphone GT-DMB-N Operation Manual

GUARD STATION
Coverage of calling from a guard station in a tenant building
Performance depends on the settings. If you cannot call even when
NOTE:
Tenant Guard st. Calling/
communication
building
✓
: :
Possible — Impossible

Calling a unit (residential/tenant station) or guard station

3-2
A
Searching for a unit by number
1
In standby mode, enter numbers using [0] to [9]
on the 10-key to display the target unit # and
resident name.
Entered number(s)
Unit # whose initial number matches the
entered number are displayed in the list.
*
The list is displayed in order of unit #.
*
This station is not displayed.
2
Select the target unit by pressing
ZOOM ZOOM ZOOM
or .
WIDE WIDE WIDE
ZOOM
ZOOM
*
Press or to turn the page of the list.
WIDE
WIDE
3
Press ( ),
When the call is answered
Communication starts and "
Same tenant building
Entrance st. Guard
st.
✓ ✓
NUMBER SEARCH
1
1 / 4
101 SMITH
102 AIPHONE
103 DENTIST
104 YOKOI
105 YABE
ZOOM
ADJUST
WIDE
or lift handset.
" is displayed.
✓
is indicated, its setting is not confi gured.
Incoming call
Other tenant buildings
Residential/ Entrance Guard
tenant st. st. st.
✓
-
4
To end communication, press
up handset.
NOTES:
• Communication will end automatically after approximately 3
minutes. Communication with a residential/tenant station in
hands-free mode ends automatically after 1 minute in hands-free
mode.
• If both unit # 111 and 1111 exist, the resident name for unit 111
will be displayed when 1, 1, 1 is entered, and the resident name
for unit 1111 will be displayed if 1 is entered one more time.
• Stations can be set to be displayed in order by unit #. (The order
starts with the lowest digit from 0 to 9 and then the order goes by
letter.) In cases where unit # such as A101, A201, A901, A1001,
and B101 exist, the order starts with the lowest digit and goes in
the order A101, A201, A901, B101, A1001.
- 24 -
Main building
Residential/ Entrance st. Guard
tenant st.
✓
- -
st.
✓
or hang