Huawei eAN3810A Hardware Installation Manual page 42

eAN3810A
Hardware Installation Guide
2.
3.
4.
Step 2 Installing the Dock Ethernet cable, as shown in
Figure 1-37 Installing the Dock Ethernet cable
(1) Ethernet cable between Dock and external
transmission device
1.
2.
The eAN3810A must be connected to the LAN0 port on the Dock. Otherwise, you are not
able to maintain the eAN3810A remotely.
----End
1.9.8 (Optional) Installing the Dock Power Cable
This section describes the procedure and precautions for installing a power cable. A Dock
input power cable connects the Dock and an external power supply device to lead external
Issue 01 (2017-04-30)
Check whether the made RJ45 connector is qualified.
To complete the assembly of the other end, repeat
Check whether the touch points on the connectors at both ends are normally conducted
and well contacted and whether the connections are correct.
Connect one end of the assembled Ethernet cable to the WAN port in the cabling cavity
of the Dock and the other end to the external transmission device.
Connect the other end of the Ethernet cable, which is connected to the PoE port on the
eAN3810A, to the LAN0 port in the cabling cavity of the Dock.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 eAN3810A Hardware Installation Guide
Step 1.1 and Step
Figure 1-37.
(2) Ethernet cable between
eAN3810A and Dock
1.2.
40