DirecTV C61W User Manual page 18

•
If the user selects Setup Instructions the instructions screen is displayed. If the user selects Setup Instructions the instructions screen is displayed. If the user selects Setup Instructions the instructions screen is displayed.
4) Select the placement for the WVB
Select a location for the WVB2 based on the following factors: Select a location for the WVB
•
Best location to provide GREE Best location to provide GREEN LED to all wireless clients(
(use 5 walls and 80 feet as the guide) (use 5 walls and 80 feet as the guide)
•
Access to the coax SWiM network. Do not connect the W Access to the coax SWiM network. Do not connect the W Access to the coax SWiM network. Do not connect the WVB2 to the coax
network yet. network yet.
5) Power on the WVB
up to a state referred to as 'Survey mode' or up to a state referred to as 'Survey mode' or 'Beacon
transmits a signal for transmits a signal for wireless clients (C41W, C61W)
sequence is as follows: sequence is as follows:
•
WVB2 LED
•
The boot up takes approximately two minutes. The boot up takes approximately two minutes.
•
Once boot up has completed, the WVB2 LED alternates GREEN/YELLOW. Once boot up has completed, the WVB
•
The WVB2
Wireless Video Bridge Survey/Beacon mode works only on WVB Wireless Video Bridge S
that have not previously been paired (factory that have not previously been paired (factory fresh) or client
reset to factory defaults. reset to factory defaults.
6) The signal strength on every wireless client ( The signal strength on every wireless client (C41W, C
checked by ensuring that the Network LED checked by ensuring that the Network LED is GREEN
Version 1.0.0 12/16/2016
FIGURE 6: C41W SIGNAL STRENGTH SCREEN
the placement for the WVB2
based on the following factors:
on the WVB2 and observe the power up sequence. and observe the power up sequence. The WVB boots
LED flashes BLUE during boot up.
2 is now in Video Bridge Survey/Beacon mode.
Page 18
User Manual –Wireless Video Bridge Gen 2 Wireless Video Bridge Gen 2
N LED to all wireless clients(C41W, C61Ws)
Beacon Mode' where it
1W). The WVB boot
LED alternates GREEN/YELLOW.
mode.
mode works only on WVB2 and clients
) or clients that have been
is GREEN
C61W) should be