Bosch MMB43...GB series Instruction Manual page 7

Add more ingredients
■ Set the rotary switch to 0/off.
Either
■ Remove lid.
■ Add more ingredients.
or
■ Take out measuring cup.
■ Add liquids and solid (fairly small) ingre-
dients through the feed tube in the lid.
■ Switch on appliance again.
Working with the smoothie insert
With this insert it is particularly easy to make
smoothies made of fresh fruits, milk, soya
milk, yoghurt and juices.
Fig. C
■ Prepare blender as described above.
■ After attaching and screwing on the
blender jug, the smoothie insert is
inserted into the blender jug.
■ Put lid on and press down all the way.
■ Insert the mains plug.
■ Put ingredients through the feed tube into
the blender jug; chop up fruit beforehand
if required.
Warning!
Do not put large, hard ingredients in the
blender jug, e.g. stones from avocados or
plums.
■ Insert measuring cup into feed tube.
■ Switch on the appliance.
After using the appliance
■ Set the rotary switch to 0/off.
■ Remove mains plug.
■ Remove the blender jug by rotating it in
an anti-clockwise direction.
■ Take the lid off the blender jug.
■ Empty blender jug.
Instructions for the smoothie insert:
Take measuring cup out of the lid and plug
into the smoothie insert. This prevents inte-
gral components from falling out of the insert
into the drink.
■ Turn blender jug over and put down with
the opening face down.
■ Remove blade holder. To do this, fold the
handle upwards and pull out the blade
holder.
■ Clean all parts, see "Cleaning and
servicing".
Universal cutter
for cutting smaller quantities of meat, hard
cheese, onions, parsley, garlic, fruit and
vegetables.
Pay attention to Figure F !
It is not permitted to cut coffee beans,
pepper corns, sugar, poppy seeds and
horseradish.
Note: If the universal cutter is not included
with the blender, it can be ordered from
customer service (order no. 12007111).
W Risk of injury from sharp blades/
rotating drive!
Do not remove or attach universal cutter until
the appliance has been switched off and the
drive has come to a standstill.
Fig. D
■ Put down universal cutter jug with the
opening face up.
■ Add food, which is to be cut, in the
universal cutter.
■ Place seal on the blade holder. Ensure
that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly posi-
tioned, liquid may run out.
■ Grip blade holder by the handle and
insert into the universal cutter jug.
Note shape of the parts (Fig. D-2)!
■ Move handle (Fig. D-3). This locks the
blade holder in the universal cutter jug.
■ Turn universal cutter jug over.
■ Place universal cutter jug on the drive on
the motor block. Arrow on the universal
cutter jug points towards the dot on the
motor block.
■ Attach universal cutter jug by turning it all
the way clockwise.
Operation en
7