Grandstream Networks GWN7600LR User Manual page 37

RADIUS Accounting Server
Secret
RADIUS NAS ID
Use MAC Filtering
Enable Dynamic VLAN (beta)
Client Isolation
Gateway MAC Address
RSSI Enabled
Minimum RSSI (dBm)
Enter the shared secret between the authenticator and the RADIUS
Accounting server if configured.
Enter the RADIUS NAS ID.
Choose Blacklist/Whitelist
excluded/included from connecting to the zone's Wi-Fi. Default is
Disabled.
When enabled, clients will be assigned IP address form corresponding
VLAN configured on the Radius user profile.
Client isolation feature blocks any TCP/IP connection between connected
clients to GWN7600LR's Wi-Fi access point.
Client isolation can be helpful to increase security for Guest
networks/Public Wi-Fi.
Three modes are available:
•
Internet Mode: Wireless clients will be allowed to access only the
internet services and they cannot access any of the management
services, either on the router nor the access points GWN7600LR.
•
Gateway MAC Mode: Wireless clients can only communicate with
the gateway, the communication between clients is blocked and
they cannot access any of the management services on the
GWN7600LR access points.
•
Radio Mode: Wireless clients can access to the internet services,
GWN7xxx router and the access points GWN7600LR but they
cannot communicate with each other.
The default value is "Disabled".
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet).
Type in the default LAN Gateway's MAC address (router's MAC address
for instance) in hexadecimal separated by ":".
Example: 00:0B:82:8B:4D:D8
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Enter the minimum RSSI value in dBm. If the signal value is smaller than
the configured minimum value, the client will be disconnected. The input
range is from "-94" or "-1".
GWN7600LR User Manual
to specify MAC addresses to be
P a g e | 37