Vega VEGAFLEX 86 Operating Instructions Manual page 32

Tdr sensor for continuous level and interface measurement of liquids

Hide thumbs Also See for VEGAFLEX 86:

Table of Contents

6 Set up the sensor with the display and adjustment module

Setup - Min. adjustment

Level

Setup - Max. adjustment -

Interface

Enter the appropriate distance value in m (corresponding to the

percentage value) for the full vessel. The distance refers to the sensor

reference plane (seal surface of the process fitting). Keep in mind that

the max. level must lie below the dead band.

In this menu item you can enter the min. adjustment for the level. With

interface measurement this is the minimum total level.

Adjust the requested percentage value with [+] and store with [OK].

Enter the suitable distance value in m for the empty vessel (e.g.

distance from the flange to the probe end) corresponding to the per-

centage value. The distance refers tot he sensor reference plane (seal

surface of the process fitting).

This menu item is only available if you have selected interface meas-

urement under the menu item "Application".

Enter the requested percentage value for the max. adjustment.

As an alternative, you have the possibility taking over the adjustment

of the level measurement also for the interface.

Enter the respective distance value in m for the surface of the upper

medium corresponding to the percentage value.

VEGAFLEX 86 • Four-wire Modbus

Table of Contents