Perform A Cold Start And Set The Default Ip Address 123.0.0.2; Setting The Default Ip Address 123.0.0.2 (Without Cold Start) - Kaba access manager 92 30 Technical Manual

Start-up
6.3.2

Perform a cold start and set the default IP address 123.0.0.2

6.3.3

Setting the default IP address 123.0.0.2 (without cold start)

72
When performing a cold start, parameters are reset to their default values. Master
records and booking records are deleted.
1. Turn off the device.
2. Turn on the device.
ð The yellow status LED is lit.
ð After approx. 40 seconds, the yellow status LED starts flashing.
3. Within 10 seconds, press the reset key and keep it depressed.
ð The status LED flashes faster for 5 seconds.
ð The status LED lights up in green for 2 seconds.
ð A cold start was performed.
ð The status LED lights up briefly in red and then flashes in red for 5 seconds.
ð The status LED flashes in green for 2 seconds.
ð The default IP address 123.0.0.2 has been set.
4. Release the reset key again.
ð The status LED is lit in green.
ð The system is ready for use, a cold start was performed, and the default IP ad-
dress 123.0.0.2 was set.
1. Turn off the device.
2. Turn on the device.
ð The yellow status LED is lit.
ð After approx. 40 seconds, the yellow status LED starts flashing.
ð After another 10 seconds, the red status LED is lit.
3. Within 5 seconds, press the reset key and keep it depressed.
ð The status LED flashes faster for 5 seconds.
ð The status LED flashes green for 2 seconds.
ð The default IP address 123.0.0.2 has been set.
4. Release the reset key again.
ð The green status LED is lit.
ð The system is ready for use, the default IP address 123.0.0.2 was set.
04045376 - 05/2016
Technical Manual
Kaba access manager 92 30