Supported Readers/Subterminals; Readers Via Wiegand - Kaba access manager 92 30 Technical Manual

Technical Manual
3.3.3

Supported readers/subterminals

3.3.4

Readers via Wiegand

Kaba access manager 92 30
The access manager (RFID device variant) supports max. 2 readers/subterminals.
Subterminal
Compact reader 91 04
Compact reader 91 10
Remote reader 91 15
Biometric reader 91 50
* not part of standard equipment, function depends on the reader driver used.
** only devices with optional RFID reader.
The readers listed above must be equipped with the firmware of "Subterminal" func-
tion type.
Power supply of the subterminals
For power supply of subterminals connected via the RS-485 interface, the 12 V DC
output voltage of the access manager can be used.
The supply of readers/subterminals by a separate external power supply is also possi-
ble.
Inputs/Outputs of the subterminals
The inputs and outputs of the subterminals can be used, thus increasing the usable
number of inputs/outputs.
The control of the door openers by means of a relay is recommended only in secured
areas.
Time-critical contacts (door frame contact) should not be queried via the inputs of
subterminals.
Two external readers can be connected to the access manager (Wiegand device vari-
ant) via Wiegand. The power supply of the readers is performed via the access man-
ager. For this purpose, 5 V DC and 12 V DC are available at Wiegand terminals.
Addressing
The addresses 1 and 2 are reserved or assigned automatically to the readers via Wie-
gand.
GID/DID Subterminal
00/01 Reader at Wiegand connection 1
00/02 Reader at Wiegand connection 2
04045376 - 05/2016
Supported function
LEGIC mode:
Reading and writing LEGIC prime (CardLink validation)
Reading and writing LEGIC advant (CardLink validation)
MIFARE mode:
Reading and writing MIFARE DESFire/Classic (CardLink
validation)
Finger template transfer via subpartyline
LEGIC mode:
Reading LEGIC prime**
Reading LEGIC advant*/**
MIFARE mode:
Reading MIFARE DESFire/Classic
Product Description
15