Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
Cover too loose
Cover too tight
Gap between roll-up bar and
tailgate
Top of tailgate hits rear bar when
attempting to close
Cover too narrow
Cover too wide
Lopsided cover (too much on one
side)
AUTOLATCH
II doesn't engage
TM
TIPS FOR A LONGER LASTING COVER
• Keep cover closed when not in use and always seal cover edges the full
length of box on both sides with hook and loop sealing system.
• Keep the cover tight; cover vinyl should sound drum-like when
tapped on.
• Make sure cover is properly latched and sealed. Lock while traveling and
before entering automatic drive-through car washes.
• Avoid storing cover in its rolled up position for long periods of time.
• When cleaning, for best results use mild liquid soap and water. Never clean
with petroleum or citrus based products.
• Periodically treat cover with our COVER CARE
instead of petroleum based products that may dry out and damage the vinyl.
• Avoid allowing cargo to rub against cover while transporting, whether in
open or closed position.
SOLUTION
Turn both tension adjusters counter clockwise to
move front bar forward. (Refer to Step 6C, see
arrows next to adjuster)
Turn both tension adjusters clockwise to move front
bar back. (Refer to Step 6C, see arrows next to
adjuster)
Rails set too high (Refer to Step 6B)
Raise side rails at rear of box until tailgate closes
without pushing rear bar up (Refer to Step 6B)
Check if rail is level. If rail tilts up, loosen clamp;
lower it; engage teeth; and tighten it. (Refer to Step
1D)
Check if rail is level. If rail tilts down, loosen clamp;
raise it; engage teeth; and tighten it. (Refer to Step
1D)
Check front bar. It must be centered side to side.
(Refer to Step 5D)
Check side rails for height and level. (Refer to Step
1F) Inspect latches for jammed or broken parts.
10
Cleaner & UV protectant
®
Advertisement
Table of Contents
