Table of Contents
Advertisement
2: APPLY ELEMENT SEAL
NOTE: For best adhesion, air and surface temperature should be above 60
Clean top of box
Align seal
against front
of rail and
inside edge of
box starting
here
NOTE: For additional protection–locate and seal miscellaneous factory
holes, crevices, stake pockets, etc. that may be on box (sealant not included).
3: APPLY REAR SEAL
NOTE: For best adhesion, air and surface temperature should be above 60
A.
Rail
Edge of
box
B.
Mark for
cutting
Rear seal
TM
Side rail (shape may
vary from photo)
Rear seal
Rail
GASKET
A. At front of box header, clean top
surface with alcohol pad (if needed
wash first). Save alcohol pad for
use in step #3.
B. Peel paper back, align and
adhere ELEMENT SEAL™ at one
corner across box to opposite corner
and cut to length.
A. Clean underside of rail with
alcohol pad included. Hold seal up
to end of rail, make sure end of seal
contacts edge of box.
B. Mark leg of seal and cut notch in
seal.
4
F.
0
F.
0
Advertisement
Table of Contents
