Cisco Nexus 9364C Hardware Installation Manual page 35

Installing the Chassis
Statement 7012—Equipment Interfacing with AC Power Ports
Warning
This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the
service equipment complying with NFPA 70, the National Electrical Code (NEC).
Warning Statement 1004—Installation Instructions
Read the installation instructions before connecting the system to the power source.
Warning Statement 1018—Supply Circuit
Take care when connecting units to the supply circuit so that wiring is not overloaded.
Before You Begin
• Switch installed in a rack and connected to an earth ground
• Recommended power cable for your nation or region
• Power source with the required amperage located within reach of the power cable being used
Connect each power supply to a power source as follows:
• Connecting an AC power supply:
1 Using the recommended power cable for your country or region (see
connect the C13 plug on the power cable to the power receptacle on the power supply.
2 Rotate the cable retention clip on the power supply over the C13 plug to prevent accidental unplugging of the
cable.
3 Connect the other end of the power cable to the AC power source.
4
Verify that the
If the LED is off, check the AC power source circuit breaker to be sure that it is turned on.
• Connecting a DC power supply:
1 Verify that the circuit breaker for the DC power source you are connecting is turned off.
2 Remove the DC power connector block from the power supply by doing the following:
a Push the orange plastic button on the top of the connector block inward toward the power supply.
b Pull the connector block out of the power supply.
3 Strip 0.6 inches (15 mm) of insulation off the DC wires that you are using.
4 Orient the connector as shown in the following figure with the orange plastic button on top.
LED is on and green.
Cisco Nexus 9364C ACI-Mode Switch Hardware Installation Guide
Powering Up the Switch
Power Cable Specifications, on page 53),
25