Basic Information (General); Intended Use; Improper Use; Warranty - KERN EMB-S 200-1S Operating Instructions Manual

2 Basic Information (General)

2.1 Intended use

The balance you purchased is intended to determine the weighing value of material
to be weighed. It is intended to be used as a "non-automatic balance", i.e. the
material to be weighed is manually and carefully placed in the centre of the weighing
pan. As soon as a stable weighing value is reached the weighing value can be read.

2.2 Improper Use

Do not use balance for dynamic weighing. In the event that small quantities are
removed or added to the material to be weighed, incorrect weighing results can be
displayed due to the "stability compensation". (Example: Slowly draining fluids from a
container on the balance.)
Do not leave permanent load on the weighing pan. This may damage the measuring
system.
Impacts and overloading exceeding the stated maximum load (max) of the balance,
minus a possibly existing tare load, must be strictly avoided. Balance may be
damage by this.
Never operate balance in explosive environment. The serial version is not explosion
protected.
The structure of the balance may not be modified. This may lead to incorrect
weighing results, safety-related faults and destruction of the balance.
The balance may only be used according to the described conditions. Other areas of
use must be released by KERN in writing.

2.3 Warranty

Warranty claims shall be voided in case
- Our conditions in the operation manual are ignored
- Appliance used outside the described uses
- Appliance modified or opened
- Mechanical damage and damage caused by media, liquids
- Natural wear and tear
- Appliance improperly set up or incorrectly electrically connected
- Measuring system overloaded
4 EMB-S-BA-e-1612