Table of Contents
Advertisement
4 | INSTALLATION INFORMATION
If the refrigerant leaks during installation, ventilate the area im-
mediately.
Toxic gas may be produced if the refrigerant comes into the place
contacting with fire.
The temperature of refrigerant circuit will be high, please keep
the communication cable away from the copper tube.
After completing the installation work, check that the refrigerant
does not leak.
Toxic gas may be produced if the refrigerant leaks into the room and
comes into contact with a source of fire, such as a fan heater, stove or
cooker.
Ground the air conditioner.
Do not connect the ground wire to gas or water pipes, light-
ning rod or a telephone ground wire. Incomplete grounding
may result in electric shocks.
Ensure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in
electric shocks.
Connect the outdoor unit first and then the indoor unit
cables.
You are not allow to connect the air conditioner with the
power source until wiring and pipework for the air condi-
tioner is complete.
While following the instructions in this installation
manual, install drain piping in order to ensure proper
drainage and insulate piping in order to prevent con-
densation.
Incorrect drain piping may result in water leakage and
property damage.
Install the indoor and outdoor units, power supply
wiring and connecting wires at least 1 metre away from
televisions or radios in order to prevent image interfer-
ence or noise.
Depending on the radio waves, a distance of 1 metre may
not be sufficient enough to eliminate the noise.
The appliance is not intended for use by young children
or infirm persons without supervision.
Do not install the air conditioner in the following loca-
tions:
■
There is petrolatum existing.
■
Salty atmosphere (near the coast). If this can't be
avoided, choose a anticorrosive model.
■
There is caustic gas (the sulfide, for example) existing
in the air (near a hot spring).
■
The Volt vibrates violently (in the factories).
■
In buses or cabinets.
■
In kitchen where it is full of oil gas.
■
There is strong electromagnetic wave existing.
■
There are inflammable materials or gas.
■
There is acid or alkaline liquid evaporating.
■
Other special conditions.
■
The appliance shall not be installed in the laundry room.
6720874436 (2017/04)
CAUTION
2.
INSTALLATION INFORMATION
■
To install properly, please read this "installation manual" at
first.
■
The air conditioner must be installed by only competent persons.
■
When installing the indoor unit or its pipe work and cabling,
please follow this manual.
■
If the air conditioner is installed on a metal part of the
building, it must be electrically insulated according to the
relevant standards to electrical appliances.
■
When all the installation work is finished, please turn on the
power only after a thorough check.
■
Regret for no further announcement if there is any change of
this manual caused by product improvement.
INSTALLATION ORDER
■
Select the location;
■
Install the indoor unit;
■
Install the outdoor unit;
■
Install the connecting pipe ;
■
Connect the drain pipe;
■
Wiring;
■
Test operation.
3.
ATTACHED FITTINGS
Please check whether the following fittings are supplied.
You may find there are extra parts supplied.
Name of Accessories
Qty
Installation manual
1
Hook
2
model
2
Hang-
36~140
ing arm
model 160
4
Network matching cable
1
Drainage pipe
1
Thermal insulation pipe
1
(160model)
Bolt assembly
4
Copper
1
Snapring
1
Outline
Usage
(This
manual)
The indoor unit which
at the terminal of com-
munication system
should connect a
impedance between
port P and port Q.
Drainage
Keep the drainage
pipe temperature
Use for pipe connec-
tion of engineering
installation
Use for fastening the
drainage pipe
Ceiling-Floor Type Indoor Unit
Advertisement
Table of Contents
