Overview - Tektronix RFA300A User Manual

Appendix C: System Recovery

Overview

RFA300A Measurement Set 8VSB
If you have problems with either BIOS configuration or system/application
software, use the procedures in this section to restore the system to factory
default installation and configuration.
NOTE. If you are restoring software after replacing the hard disk drive with one
you ordered as a replacement from Tektronix, follow the instructions provided
with the hard disk drive replacement.
If you are restoring software after reformatting the hard drive, perform all of the
procedures in this section in sequence.
These procedures require the RFA300A System and Application Restore Media
CD-ROM, which was shipped with the RFA300A Measurement Set 8VSB.
Installation should only be performed by a qualified technician who is familiar
with installing drivers and configuring for networking.
These tips apply to the procedures in this section:
H Use default settings unless otherwise indicated in the following procedures.
H These procedures use drive "e:" as the CD-ROM drive.
H At the end of some steps, you are instructed to restart the system. To do this,
if you are prompted to restart, select Yes. If not prompted, select Shutdown
from the Start menu and then select Restart the computer.
You can use the procedures in this section to do any of the following:
H Restore the system BIOS settings to factory defaults.
H Restore a part of the system.
H Restore the complete system, including installation and configuration, to
factory defaults.
C- 1