Honeywell HZ-860 Series User Manual page 4

OPERATION
(CONTINUED)
EnergySmart Mode -
®
A smart thermostat that helps you save energy. Press SET to choose four (4) comfort settings of 65°
(18°), 70° (21°), 75° (23°), 80° (26°). The EnergySmart Mode is a smart thermostat. The EnergySmart
thermostat will automatically select the appropriate power level to best accommodate your Desired
Temperature. As the air temperature (Current Temp) in the room approaches the Desired Temperature,
the heater will automatically lower the power consumption to provide consistent warmth without
wasting energy.
The Current Temp Indicator will display the current room temperature.
To override the EnergySmart ® function, simply press SET to choose either OFF (
LOW or HIGH Continuous Heat.
SAFETY FEATURES
This heater is equipped with several devices and features for added protection:
• A tip-over switch that disables the heater if it is accidentally tipped –
• Model HZ-850 Series - 2 way shut off disabled heater if tipped front or back directions
• Model HZ-860 Series - 4 way shut off disables heater if tipped front, back or side to side
directions
• A high temperature safety sensor prevents overheating.
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater
should it operate at a higher than normal temperature.
• This heater was built using a high temperature plastic and has a cool to touch housing and handle.
CLEANING AND STORAGE
We recommend that this heater be cleaned at least once a month and before off-season storage.
• Turn the heater OFF ( ) or ( ) and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTIONS.
• Before storing, clean the ThermaWave Heater using the above-mentioned steps. Wrap the cord
around the unit. Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.
6
TROUBLESHOOTING
If your heater shuts off unexpectedly or fails to operate, one of your heater safety features may have been
activated to prevent overheating.
®
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstructions. If you find an obstruction, turn the heater OFF (
• Allow the heater to cool completely, then remove the obstruction. Wait at least 10 minutes, then plug
the heater in and follow the OPERATION instructions
),
PRODUCT SPECIFICATIONS
Model(s)
Unit Dimensions HZ-850/HZ-860 Series - 17.3" L x 8.5" W x 18" H (assembled)
Amps
Unit Voltage
Max Watts
Max BTUs
Operation Cost*
To estimate the cost to operate this heater, multiply the watts used times .001 to convert into
a kilowatts measure and multiple by your local kilowatt electric rate for however long you run the
heater. For example, if your electric rate is $.1196** per kilowatt hour and you ran this heater in
constant high mode (1500 watts) for 4 hours, it would cost you $.71 cents to run the heater
(1500 watts x 4 hours x .001) x .1196kwp = .71 cents)
NOTE: Because the Low (
electricity to operate, they are more energy efficient and may be better options if you are concerned
about the amperage draw on a circuit when the heater is on the High (
*Calculation (Total Wattage x .001) x Cost per Kilowatt Hour = Cost to operate
**Average Retail Price of Electricity to Ultimate Customer by End-Use, US Energy Information Administration,
August 11, 2010
CONSUMER RELATIONS
Call us toll-free at: 1-800-477-0457
E-mail: consumerrelations@kaz.com
Or visit our website at: www.HoneywellPluggedIn.com/heaters
Please be sure to specify a model number.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE
YOUR WARRANTY. DO NOT RETURN THE HEATER TO THE ORIGINAL PLACE OF PURCHASE. DO NOT
ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND
CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.
HZ-850 Series, HZ-860 Series
12.5
120V, 60Hz
1500
5118
) or EnergySmart® (HZ-860 Series) settings do not require as much
) or ( ) and unplug it.
) setting.
7