Table of Contents
Advertisement
22
www.electrolux.com
A
A
D
A 548 mm
N 550 mm
4. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
13.2 Installing the oven under a
work surface
Before the installation, connect the oven
to the electrical supply. Refer to "Electrical
connection".
During installation in
combustible matter, NIN SEV
1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be strictly
adhered to.
1. Pull the appliance drawer out as far as
it goes and remove it.
2. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
A
A
A
60
mm
N 605
mm
A 567
mm
A
3. Push the appliance into the recess.
A = appliance, N = recess
~50 mm
A
A
757 mm
170
N 762
mm
mm
A
435
5 / 6 =
mm
635 mm
6 / 6 =
762 mm
105
mm
N 550 (-0,+1) mm
4. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
When installing next to a wood-fuelled
boiler, a heat-proof and heat-insulating
plate must be mounted at the height
of the appliance and at least 30 cm
deep.
13.3 Electrical connection
Use a power cable of H05VV-F or higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must include
an isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
600 mm
A
A
160
mm
A 767
N 780
20
D
mm
mm
mm
A 549 mm
A
B
20 mm
WARNING!
If service is required always
disconnect the appliance
from the power supply.
B
~50 mm
N 762 + 3
A
mm
A 757
mm
A
435
mm
170
mm
min. 20 mm
10
mm
A
Advertisement
Table of Contents
