Table of Contents
Advertisement
Problem
The display shows an error
code that is not in this ta-
ble.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
13. INSTALLATION
WARNING!
Refer to Safety chapters.
13.1 Building in
During installation in
combustible matter, NIN SEV
1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be strictly
adhered to.
Possible cause
There is an electrical fault.
The demo mode is activa-
ted.
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
.........................................
.........................................
.........................................
1. Pull the appliance drawer out as far as
2. Place the appliance in front of the
3. Push the appliance into the recess.
Remedy
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
1. Deactivate the oven.
2. Touch and hold
the oven activates and
deactivates.
3. Touch and hold
at the same time un-
til an acoustic signal
sounds and "Demo"
goes out.
it goes and remove it.
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
A = appliance, N = recess
ENGLISH
21
until
and
Advertisement
Table of Contents
