Settings; Information For Test Institutes; The Water Softener - Atag VA63211VT User Manual

8
1)
Programme
P5
P6
P7
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the values.

Information for test institutes

For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

SETTINGS

Programme selection mode and
user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener according
to the water hardness.
• The activation or the deactivation of the
acoustic signal for end of programme.
• The selection of the colour for
TimeBeam.
• The activation or deactivation of the rinse
aid dispenser when you want to use the
Multitab option without rinse aid.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
Water
(l)
10
4
9 - 10
Write down the product number (PNC) that
is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
When you activate the appliance, usually it
is in programme selection mode. However,
if this does not happen, you can set the
programme selection mode in the following
way:
Press and hold simultaneously
until the appliance is in programme
selection mode.

The water softener

The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
Energy
(kWh)
0.9
0.1
1.0 - 1.2
Duration
(min)
30
14
219 - 229
and