Initial Connection And Configuration; Establishing A Connection - Emerson Smart Wireless Gateway 1420 Quick Start Manual

January 2015
Step 1: Initial connection and configuration
™
DeltaV ready
If the Gateway was ordered DeltaV Ready (Data Protocols Code 5), then

Initial connection and configuration

installation, and connect the Gateway to a DeltaV 10.3 or newer control network.
Initial connection and configuration
To configure the Smart Wireless Gateway, a local connection between a
PC/laptop and the Gateway needs to be established.
Powering the gateway
Bench top power will be needed to power the Gateway by wiring a 24 VDC
(nominal) power source, with at least 250 mA, to the power terminals.
Figure 1. Gateway Terminal Block Diagram
24 VDC
(nominal)
Power Input
+
Case
Ethernet 2
with Power
(Covered)

Establishing a connection

Note
For information on connecting a Windows 7 PC, see the technical note (document number
00840-0900-4420).
1. Connect the PC/laptop to the Ethernet 1 (Primary) receptacle on the Gateway.
- S A
Ethernet 2 Ethernet 1
(Secondary) (Primary)
is not required. Proceed to
Serial
Modbus
Not Used
+
B
+
Not Used
Quick Start Guide
Step 2: Physical
Not Used
-
-
S S
-
S S -
Not Used
Step 1:
+
+
5