Stamina 7500 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
METAL FITTING
CABLE END
BRACKET
SPRING HOOK
STEP 6:
Pull the ends of the
FRAME(1).
Slide the
CONNECTION WIRE(33)
WIRE(34).
Slide the
careful not to damage the
BUTTON HEAD BOLTS(M8 x 15mm)(56)
secure with
UPRIGHT SLEEVE(39)
NOTE: Be careful not to damage the
UPRIGHT SLEEVE(39).
the
STEP 7: TENSION KNOB(31)
Turn the
CABLE END
the on the
CABLE(30).
Pull on the
through the slot in the
at the end of the slot in the
UPRIGHT(3) SCREW(M5 x 15mm)(77).
with
STEP 8: "AA"
Install two
WIRE(33) METER(32).
into the
SCREWS(M5 x 10mm)(76).
with
NOTE: Be careful not to damage the wires when sliding the
TENSION CABLE(30)
UPRIGHT SLEEVE(39)
UPRIGHT(3)
into the
TENSION CABLE(30)
SENSOR WIRE(34).
down to cover the bolts on the
WARNING LABEL(82)
TENSION KNOB(31)
TENSION KNOB(31)
BRACKET.
Then insert the metal fitting on the
BRACKET.
batteries into the
Slide the
and
UPRIGHT(3).
onto the
from the top end and connect it to the
into the bottom end of the
UPRIGHT(3)
Insert the
and
UPRIGHT(3).
counterclockwise to fully extend the
SPRING HOOK
to the
firmly so that enough cable is available to insert the cable
TENSION KNOB(31)
Attach the
METER(32),
two batteries included. Plug the
METER(32)
onto the plate on the
METER(32).
8
SENSOR WIRE(34)
Insert the female end of the
UPRIGHT(3). NOTE:
MAIN FRAME(1)
onto the
ARC WASHERS(M8)(75).
UPRIGHT(3)
placed on the
CABLE END.
on the end of the
TENSION KNOB(31)
onto the bracket on the
UPRIGHT(3)
( FEMALE END )
MAIN
out of the
SENSOR
Be
and
Slide the
when sliding
Connect
TENSION
into the hole
CONNECTION
and secure