Table of Contents
Advertisement
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board
5
on the bottom of the hard disk drive.
Figure 59. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 60. Installing the primary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Secondary hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Note: Your computer comes with a secondary storage drive bay for installing or replacing a secondary
3.5-inch hard disk drive or a 2.5-inch solid-state drive.
To replace the secondary hard disk drive, do the following:
126
ThinkStation P410 Hardware Maintenance Manual
1
, pin
2
, pin
3
, and
Hide quick links:
Advertisement
Table of Contents
