Miscellaneous Error Conditions - Lenovo ThinkStation P410 Hardware Maintenance Manual

8999

Miscellaneous error conditions

Message/Symptom
Changing display colors
Computer will not power-off. See "Hard disk drive boot
error" on page 88.
Computer will not RPL from server
Computer will not perform a Wake On LAN
Dead computer. See "Hard disk drive boot error" on page
88.
Diskette drive in-use light remains on or does not light
when drive is active.
Blank screen except for flashing cursor.
Incorrect memory size during POST
Not enough PCIe/PCI MMIO
resources. Currently only one video
card is enabled. Remove some PCIe
cards, or enter BIOS Setup and
enable "Above 4GB Decode"
FRU/Action
Display/Monitor
1. Power Switch
2. System Board
3. Riser card, if installed.
1. Ensure that network is in startup sequence as first
device or first device after diskette.
2. Ensure that network adapter is enabled for RPL.
3. Network adapter (Advise network administrator of
new MAC address)
®
(if applicable) 1. Check power supply and signal cable connections
to network adapter.
2. Ensure that the operating system settings are set to
enable Wake on LAN.
3. Ensure Wake On LAN feature is enabled in
Setup/Configuration (see "Starting the Setup Utility
program" on page 63)
4. Ensure network administrator is using correct MAC
address.
5. Ensure no interrupt or I/O address conflicts.
6. Network adapter (advise network administrator of
new MAC address)
1. Power Supply
2. System Board
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. System Board
2. Primary Hard Disk Drive
3. Hard Disk Drive Cable
1. Run the Memory tests.
2. Memory Module
3. System Board
Chapter 8
set UEFI as the first priority or disable
CSM in BIOS setup.
This error message is displayed
when the PCIe/PCI MMIO (memory
mapped input/output) resources are
insufficient.
For the 32-bit operating system,
remove some add-in cards.
For the 64-bit operating system,
enable Above 4 GB Decode in BIOS
setup.
.
Service checkout and symptom-to-FRU index
91