Lenovo ThinkStation P410 Hardware Maintenance Manual page 152

5. Slide the new slim optical drive with the plastic clip into the flex module until the slim optical drive
snaps into position.
Figure 87. Installing the slim optical drive in the flex module
6. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 88. Reinstalling the flex module cover
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
eSATA connector or IEEE 1394 connector
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Optical drive" on page 111.
144
ThinkStation P410 Hardware Maintenance Manual