Garmin GIA 63 Installation Manual page 42

The following is a list of known TSO-C144 antennas that allow the GIA 63W and GIA 63H with any
version of GPS software version to meet TSO-C145a requirements with the operational limitations
specified in Section 1.6.5 of this manual:
Mount
Model
Style
Screw
A-34 GPS Mount,
WAAS Antenna Teardrop
Footprint [2]
Screw
GA56A GPS Mount,
WAAS Antenna ARINC 743
Footprint
Stud Mount,
GA56W GPS
Teardrop
WAAS Antenna
Footprint [1]
Screw
GA57 GPS
Mount,
WAAS and FIS
ARINC 743
Antenna
Footprint
[1] Same footprint and mounting hole pattern as GA 56.
[2] Same mounting hole pattern as the GA 56, but has a physically larger footprint.
[3] SATCOM compatibility requirements are as specified by RTCA/DO-229C Section 2.5.6.1, Section
2.5.8.2, Appendix C.2.1, and Appendix C.2.2.
[4] The WAAS GPS antenna connector is a BNC type. The XM antenna connector is a TNC type.
[5] The WAAS GPS antenna connector (and XM antenna connector where applicable) is TNC type. The
VHF COM antenna connector is BNC type.
[6] Not approved for use with the GIA 63 (non-WAAS) since max DC current specification exceeds
40 mA.
[7] Larger footprint and mounting hole pattern than GA 56, GA 35 or CI 2580.
[8] It is the installer's responsibility to ensure the antenna complies with Antenna Minimum Performance
Specification for Garmin's GPS/WAAS Receiver System Antenna (004-00287-00) by
communicating the requirement to the supplier and obtaining a certificate of compliance to
004-00287-00 from the supplier. An antenna that complies only with TSO-C144 requirements is not
adequate for this installation.
Other TSO-C144 antennas may meet the installation requirements of the GIA 63W and GIA 63H.
Contact Garmin to ensure compatibility and applicable operation limitations before beginning the
installation.
Page 2-4
Revision T
SATCOM
Conn
Compatible
Type
[3]
Antenna
TNC Yes
Garmin AT
BNC No
BNC No
BNC
TNC No
[4]
Antenna
Mfr Part
Number
AT575-93W-
Aero
TNCF-000-05-
26-NM
590-1112
Garmin 011-01154-00
Garmin 011-01111-00
Garmin 011-01032-00
Garmin
Additional
Order
Requirements
Number
013-00113-00
The operational
limitation
described in
Section 1.6.5
010-10599-00
requires use of
006-A0154-01
as the Prediction
Program in
conjunction with
010-10561-01
these antennas.
010-10604-00
GIA 63 Installation Manual
190-00303-05