Garmin GIA 63 Installation Manual page 40

Line replaceable unit
Hide thumbs Also See for GIA 63:
Table of Contents

Advertisement

2.1.2 Required Accessories
Each of the following accessories is provided separately from the GIA 63(X). Either rack (modular,
standalone, or helicopter) and remainder of the accessories are required for installation.
GIA 63(W) Modular Install Rack
or
GIA 63(W) Standalone Install Rack
or
GIA 63H Helicopter Install Rack*
G1000 Rack Nutplate Kit (Modular Rack Only)
GIA 63(W) Back Plate (Modular and Standalone)
GIA 63H Back Plate (Helicopter)*
GIA 63(X) Connector Kit w/ Spider
GIA 63(X) Connector Kit w/ Shield Block*
*Only the 010-00386-30 GIA 63H unit together with the 011-02425-00 Rack , 011-00963-01 Back Plate,
and 011-01000-01 Connector Kit is approved for DO-160F, Category U, Curve G vibration levels.
2.1.3 Additional Equipment Required
The following installation accessories are required but not provided:
Shall meet TSO-C37(), C38(), and C-169()*. Broad band, 50 Ω, vertically
COM Antenna:
polarized with coaxial cable
GPS Antenna:
GIA 63 (Non-WAAS) shall meet TSO-C129a. TSO-C144 antennas can also meet
TSO-C129a requirements for the GIA 63 (Refer to Section 2.1.3.1).
GIA 63H and GIA 63W (WAAS) shall meet TSO-C144 and additional system
requirements specified by TSO-C145a. Refer to Section 2.1.3.2 for approved
antennas
VOR/LOC Antenna: Shall meet TSO-C40() and C36(). Broad band, 50 Ω, horizontally polarized with
coaxial cable
Glideslope Antenna: Shall meet TSO-C34(). Broad band, 50 Ω, horizontally polarized with coaxial
cable or low-loss splitter used with the VOR/LOC antenna
500 Ω nominal impedance Microphone: Low impedance, carbon or dynamic, with
Headphones:
transistorized pre-amp
Hardware:
#6-32 x 100°Flathead SS Screw [(MS24693, AN507R or other approved fastener)
(4 ea.)] for horizontal mounting of the standalone rack.
Hardware:
#8-32 Panhead Machine Screw [(MS35206, AN526 or other approved fastener)
(4 ea.)] for vertical mounting of the standalone rack.
Hardware:
#10-32 x 100°Flathead Screw [(MS24694S51 or screw of same or greater
strength)(4 ea.)] for mounting of the helicopter rack.
*GIA 63W and GIA 63H only
Page 2-2
Revision T
Item
Garmin P/N
115-00426-00
115-01239-00
011-02425-00
011-00915-01 (preferred)
or
011-01148-01
011-00963-00
011-00963-01
011-01000-00
011-01000-01
GIA 63 Installation Manual
190-00303-05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents