Garmin GIA 63 Installation Manual page 13

Line replaceable unit
Hide thumbs Also See for GIA 63:
Table of Contents

Advertisement

1.4.6 COM Transceiver Specifications
Characteristics
Audio Output
Audio Response
Audio Distortion
AGC Characteristics
Sensitivity
Squelch
Selectivity
Spurious Response
Transmitter Power
Transmitter Duty Cycle
Modulation Capability*
Carrier Noise Level
Frequency Stability
Demodulated Audio Distortion
Sidetone
Demodulated Audio Response
*When utilizing the configurable microphone gain adjustments, the modulation capability specification
can be met with a 70 mVrms to 3.0 Vrms analog microphone input signal applied to the transmitter.
When a digital audio microphone signal is provided by a compatible Garmin audio panel, the modulation
capability specification can be met with a minimum 70 mVrms microphone input signal applied to the
audio panel.
GIA 63 Installation Manual
190-00303-05
100 mW minimum into a 500 Ω load.
Less than 6 dB of variation between 350 and 2500 Hz.
The distortion in the receiver audio output shall not exceed
25% at all levels up to 100 mW.
The audio output shall not vary by more than 6 dB when the
level of the RF input signal, modulated 30% at 1000 Hz, is
varied from 5 μV to 100,000 μV (hard).
(S+N)/N on all channels shall be greater than 6 dB when the
RF level is 2 μV (hard) modulated 30% at 1000 Hz at rated
audio.
2 μv (hard) ±6 dB for 25 kHz channels.
3 μv (hard) ±6 dB for 8.33 kHz channels.
6 dB BW is greater than ±8 kHz for 25 kHz channeling.
60 dB BW is less than ±25 kHz for 25 kHz channeling.
6 dB BW is greater than ±2.778 kHz for 8.33 kHz
channeling.
60 dB BW is less than ±7.37 kHz for 8.33 kHz channeling.
Greater than 80 dB.
At Least 16 watts when Vin = 28 VDC
At least 10 watts when Vin = 14 VDC (011-01105-2X and
011-01105-3X only)
Recommended 10% maximum.
The modulation shall not be less than 70% and not greater
than 99.9% with a standard modulator signal applied to the
transmitter.
Shall be at least 45 dB (S+N)/N.
0.0005%
Less than 10% distortion when the transmitter is modulated
at least 70%.
into a 500 Ω load when the transmitter is modulated
1.4 V
RMS
at least 70%.
Shall be less than 6 dB when the audio input frequency is
varied from 350 to 2500 Hz.
Specifications
Page 1-5
Revision T

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents