Table of Contents
Advertisement
5.1,1
Auto Tap Test
The
auto
tap
action. To initiate the auto tap test, use the following
procedure.
a.
Turn off the power to the disk drive.
b.
Connect diagnostic pin T2 to the center pin.
c.
Select head load jumper position HL2 and connect HL2
to ground.
d.
Turn on the power to the disk drive to start the
auto tap test.
5.1.2
Auto Seek Test
The auto seek test consists of a continuous track seek, from
track 0 to track 76, with the read/write heads unloaded.
Select the auto seek test as follows.
a.
Turn off the power to the disk drive.
b.
Connect diagnostic pin T3 to the center pin.
c.
Turn on
auto seek test.
5.1.3
Auto Seek and Auto Tap Test
The auto seek and auto tap test performs the auto seek and
auto tap functions simultaneously.
auto tap test as follows.
a.
Turn off the power to the disk drive.
b.
Connect diagnostic pins T2 and T3 to the center pin.
c.
Select head load jumper position HL2 and connect HL2
to ground.
d.
Turn on
auto seek and auto tap test.
5.2
HEAD UNLOAD DELAY
To delay the head unload action by 250 ms, short pin Tl (see
Figure
5-1) to
head load/unload actions
occur.
Normally this pin is open.
test
consists
the power
to the disk drive to start
the power to the disk drive to start
ground.
With Tl shorted to ground,
(less than 250 ms apart)
5-2
of
a head
load/head
Select the auto seek and
unload
the
the
rapid
cannot
Advertisement
Table of Contents
