To replace the head load cam assembly,
a.
Hold the head load cam assembly against the refer
ence
surface
screws (see Figure 4-7).
b.
Run the wiring harness through the base frame and
fasten
clips.
c.
Replace the PCB.
Figure 4-7
4.4.5
Write Protect Sensor and Media-In Sensor Removal
and Replacement
Use the following procedure to remove either sensor.
a.
Removing the screw that fastens the sensor to the
base frame assembly.
b.
Remove the heat-shrinkable tubing from the sensor
connections and unsolder the wires (see Figure 4-8).
of
the
it to the base frame with
Installing the Head Load Cam Assembly
4-9
base
frame
and
the appropriate
install
the