Pop-Up Assembly Removal And Replacement; Adjusting The Picker Rod - NEC FD1165 Maintenance Manual

c. Tighten the screw.
d. Check the operation of the picker rod (see Section
4.4.15) .
Figure 4-17
4.4.13

Pop-Up Assembly Removal and Replacement

Use the following procedure to remove the pop-up assembly.
a. Remove the lever plate by removing the four screws
that secure it to the lever plate hinges.
b. Loosen
screws that fasten it to the base frame (see Figure
4-18).
c. Move any wiring that is in the way and lift the
pop-up assembly out of the base frame.

Adjusting the Picker Rod

the pop-up assembly
4-18
by removing the two