Testing The Fuse - Fluke 1587 FC Calibration Manual

Testing the Fuse

To avoid electrical shock or injury, remove the test leads and
any input signals from the Meter before replacing the fuse.
Test the fuse as described below and illustrated in Figure 1. If the fuse is
defective, see Replacing the Batteries and/or Fuse later in this manual.
1. Insert a test probe in the J input terminal.
2. Turn the rotary switch to N and verify the Meter is in Auto Range.
3. Insert the probe in the mA input terminal. If the display reading is , the fuse
is defective; replace the fuse.
XWWarning
Figure 1. Testing the Fuse
Insulation Multimeters
440 mA
OK
Basic Maintenance
bav14f.eps
13