The Galley; Sink Countertop; Ice Maker - Bayliner 4788 Operation Manual

Operating Manual for Sea Daze 4788 Bayliner

7.2 The Galley

The galley is fully equipped with a number of appliances for your convenience. Most of these are easy to
operate. Nevertheless, there are some features that are different than a home model.

Sink Countertop

7.2.1
Please protect countertops and sinks from damage. Use the cutting boards supplied.
Keep the countertops dry, Avoid splashes.
Refrigeration
The refrigerators are dual voltage (110 volt AC and 12 volt DC) and will automatically use the 110-volt power
when shore power/generator is on and DC power when AC is not available.
Galley Refrigerator-Freezer
Leave both refrigerator breakers in the ON position. Carefully monitor the use of the each refrigerator when on
12-volt power such as when you are at anchor as they can drain the batteries rather quickly. Use a cooler when
available to keep the refrigerator door closed as much as possible.
The Galley REFRIGERATOR-FREEZER is a Nova Cool 7.0-cu-ft model. To operate the galley fridge:
• Turn ON the REFRIGERATOR switch on the Pilothouse DC Panel
• Turn ON the REFRIGERATOR switch on the Pilothouse AC Panel
• Turn ON the power switch below the refrigerator door and adjust the temperature
Fly Bridge Refrigerator
The Bridge REFRIGERATOR is a Norcold 2.7-cu-ft model. To operate the Bridge Fridge/
• Turn ON the ENTERTAINMENT CENTER switch on the Pilothouse DC Panel
• Turn ON the BRIDGE REFRIGERATOR switch on the Pilothouse AC Panel
• Turn ON the local power switch in the fridge and adjust the temperature
CAUTION – The bridge refrigerator consumes much DC power. Use it selectively, or rely on a cooler. It also
creates overhead motor noise in the Salon.
Adjust the temperature to conserve power. A setting of 2.5 or 3 should be good for AC setup. It is advisable to
turn the setting lower when on battery power and consider turning it off at night.

7.2.2 Ice Maker

The ICE MAKER is located in the Salon starboard. Turn ON the ICEMAKER switch on the Pilothouse AC
Panel. The device power switch is reached through a finger hole at the top of the front grill, just below the door
-- it is normally ON.
Swing the ice sensor bar-switch to the downward position to start ice-making.
The Ice Maker is connected to the Inverter system -- it will continue to operate when AC shore power or
generator are not used.
Ensure the plastic bin is in icemaker. Should power be turned OFF, the melting water will soak the carpet.
th
Sea Daze 160323.doc Page 33 of 44 Last Revision August 11 , 2015