Dell Dimension V400 Service Manual page 55

drive-mounting screws (3)
)LJXUH   /RZHU ,QFK 'ULYH 5HPRYDO 0LQL 7RZHU
&RPSXWHU 2QO\
The lower 3.5-inch drive attaches to the left side and bottom of the drive cage.
To remove a drive from the lower 3.5-inch drive bay in the mini tower com-
puter, follow these steps:
1. Remove the bezel.
2. Remove the drive cage and drives as an assembly.
3. Remove the three drive-mounting screws, one from the bottom and two
from the left side (see Figure 4-9). Then slide the drive out of the drive
cage.
When you replace a drive, be sure to set the jumpers on the replacement drive
the same as the jumpers on the drive you removed. For additional information
about jumper settings on EIDE drives, see "EIDE Subsystem" in Chapter 1.
In the bottom of the bay, there are two small grooves that the bottom drive
must engage to slide back into the bay.
Removing and Replacing Parts 4-11