Upper 3.5-Inch Drive - Dell Dimension V400 Service Manual

4-10 Dell Dimension V xxx and V xxx c Systems Service Manual
)LJXUH  8SSHU ,QFK 'ULYH 5HPRYDO
To remove an upper 3.5-inch drive, follow these steps:
1. Remove the bezel.
2. Remove the drive cage and drives as an assembly.
3. Remove the plastic insert from the bezel.
4. Remove the x
6/32
cage, and then remove the bracket as shown in Figure 4-8.
NOTES: The three screws used to secure the drive to the bracket and to
the left side of the drive cage have 3-mm threads. Be sure to use the cor-
rect 3 x 5-mm screws when you secure the drive to the bracket and the
drive to the cage.
Also note which screw was used to secure the drive bracket to the drive
cage in step 4, and use the same
bracket with its attached drive.
When you replace a drive, be sure to set the jumpers on the replacement drive
the same as the jumpers on the drive you removed. For additional information
about jumper settings on EIDE drives, see "EIDE Subsystem" in Chapter 1.
-inch screw securing the drive bracket to the drive
1/4
x
6/32 1/4
drive-bracket
mounting screw
screws for
drive assembly (3)
drive bracket
-inch screw when reinstalling the