Dell Dimension V400 Service Manual page 41

7DEOH  6\VWHP 0HVVDJHV
0HVVDJH
CD ROM drive
Identified
Diskette drive A
error
Entering Setup
Extended RAM
Failed at off-
set: nnnn
Failing Bits:
nnnn
Fixed Disk n
Failure
Fixed Disk Con-
troller Failure
Fixed Disk n
Identified
Incorrect Drive x
type - Run SETUP
Invalid NVRAM
media type
Invalid system
configuration
data
FRQWLQXHG
3UREDEOH &DXVHV
System's automatic
drive-type detection
feature identified
CD-ROM drive.
Drive A present but
failed BIOS POST.
System is starting sys-
tem setup program.
Extended memory not
working correctly or not
configured correctly at
offset nnnn .
nnnn is a map of the
bits at the RAM address
(in system, extended, or
shadow memory) that
failed memory test.
Each "1" in the map
indicates a failed bit.
Hard-disk drive speci-
fied by n not working or
not configured correctly.
System's automatic
drive-type detection fea-
ture identified hard-disk
drive(s).
Diskette drive x not cor-
rectly identified in
system setup program.
System having a prob-
lem accessing NVRAM
(CMOS).
System configuration
information in system
setup program is incor-
rect, or battery charge
may be low.
Diagnostic Codes, Beep Codes, and Error Messages
&RUUHFWLYH $FWLRQ
No action necessary.
Ensure that drive is
installed correctly and
defined correctly in
system setup program.
No action necessary.
Enter system setup
program and restore
original value(s).
Enter system setup
program and restore
original value(s).
Ensure that drive is
installed correctly and
defined correctly in
system setup program.
No action necessary.
Ensure that drive is
defined correctly in
system setup program.
Set system configura-
tion jumper to
Maintenance mode;
reboot system to clear
all settings to their
defaults.
Enter system setup
program, and verify
system configuration
information; reboot
computer.
3-5