Inch Drive - Dell Dimension V400 Service Manual

4-8 Dell Dimension V xxx and V xxx c Systems Service Manual
retaining hook
)LJXUH  ,QFK ,QVHUW 5HPRYDO
To remove a 5.25-inch drive, follow these steps:
1. Remove the bezel.
2. Remove the drive cage and drives as an assembly.
3. If you are installing a drive in the lower 5.25-inch bay, remove the front-
panel insert shown in Figure 4-6 by pressing in the two tabs on the right
side and rotating the insert toward you until the retaining hook disengages
from the drive cage.
If you later permanently remove the drive, reinstall the insert by fitting the
hook into the slot on the left side of the drive cage, rotating the insert into
place, and snapping the tabs on the right side of the insert into the slots in
the drive cage.
4. Remove the three drive-mounting screws, and slide the drive out of the
bay as shown in Figure 4-7 .
)LJXUH  ,QFK 'ULYH 5HPRYDO
tabs (2)
front-panel insert
drive-mounting
screws (3)