Step 2 - Filling With Engine Fuel; Operating The Lawnmower; Step 1 - Setting The Cutting Height; Step 2 - Starting The Engine - Qualcast XSZ46B-SD Assembly Manual

Preparing to Operate the Lawnmower

Step 2 - Filling with Engine Fuel

CAUTION! Always use clean, fresh unleaded petrol. Purchase fuel in quantities that can be used
within 30 days. Never mix oil with petrol.
CAUTION! Do not fill into the base of neck to allow for fuel expansion. Do not overfill the fuel tank.
CAUTION! WARNING! Petrol is highly flammable and extreme precaution must be taken when
handling or working with it. Keep out of reach of children.
CAUTION! To prevent engine damage the engine is shipped without oil or petrol. The engine must
be filled with the correct grade of oil and petrol before starting the engine.
WARNING! Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flames
or sparks in the area where the engine is refueled or where petrol is stored. Avoid repeated or
prolonged contact with skin or inhalation of vapour.
Clean the area around the petrol filler cap before removing the cap. Remove the warning tag,
check the fuel level.
Refill the tank if the fuel level is low.
Refuel carefully to avoid overfilling or spilling fuel. There should be no fuel in the filler neck.
Clean up any overflow or splashes of petrol before starting the engine.
Tighten the filler cap after filling, finger tight only.
Customer Helpline 0845 034 2279
8
www.gardenservicecentre.co.uk

Operating the Lawnmower

Step 1 - Setting the Cutting Height

1
WARNING! The blade can cause serious injury. Before adjusting the mower height, stop the engine
and wait for the mower blade to stop completely.
Pull the lever towards the wheel, then move it forward or backward to adjust the cutting height
Move it to any one of the 7 positions for the desired cutting height;
Return lever into securing plate.

Step 2 - Starting the Engine

PRIMER BULB 3~5 STOP/START-LEVER
TIMES CLOSED
1 2
Starting procedure quick guide
WARNING! Do not operate the machine in enclosed or poorly ventilated areas as the exhaust
gas contains toxic substances. Keep hands, feet, hair and clothing away from all the moving
parts of the machine. The exhaust and other parts of the machine will become hot during use.
Make sure that the blade is securely fastened before starting the engine.
NOTE! To start the engine, make sure that the spark plug cap is located on the plug and the
machine is filled with sufficient oil and petrol.
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
2
PULL STARTING PROPULSION-LEVER
-KNOB CLOSED
3 4
9