Maintenance And Storage Safety; Preparing To Operate The Hand Push Mower; Step - Adjusting The Cutting Height - Qualcast GSS380 Assembly Manual

Safety Information
Important - Please read these instructions fully before operating or maintaining
Operation Safety (continued)
- Operation on slopes requires extra caution. Slopes are a major factor related to slip and fall
accidents, which can result in severe injury. If you feel uneasy on a slope, do not mow it. If the
slope is greater than 15 degree, do not mow it.
- Mow across the face of slopes; never up and down. Be cautious caution when changing
direction on slopes.
- Watch for holes, tree roots, rocks, hidden objects or bumps which can cause you to slip or trip.
Tall grass can hide obstacles.
- Always be sure of your footing. A slip and fall can cause serious personal injury.

Maintenance and Storage Safety

WARNING!
- Maintain tools with care. Keep tools clean and in good condition for better and safer
performance. Follow the instructions for maintenance.
- Keep cutting blades sharp and clean. Properly maintained cutting blades with sharp cutting
edges are less likely to bind and easier to control. Wear gloves,and use extra caution when
maintenance.
- Store idle tool out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the tool. Tool is dangerous in the hands of untrained users.
Service
This tool is manufactured in accordance with the relevant safety regulations. To avoid danger,
equipment must only be repaired by qualified technicians.
- Only use parts and accessories made for this machine by the manufacturer. Failure to do so
can result in presonal injury.
Intended Use:
This mower is designed for domestic lawn mowing only. Use in any other way is considered
contrary to the intended use. Compliance with the operation, service and repair as specified in
this handbook also constitute essential elements of the intended use.
Customer Helpline
6
www.gardenservicecentre.co.uk
01904 727500

Preparing to operate the Hand Push Mower

Step 1 - Adjusting the cutting height
5
- Loosen wing nut ( 5) both sides of the mower. Move both roller brackets ( 4) equally to the
required height of cut.
To change the height of cut,
1. Remove the wing nut (5) and bolt
2. Reposition the bolt for required height of cut.
3. Refit wing nut (5)
The roller brackets (4) should be set in one of the three positions according to the type of lawn:
I for high range of bumpy lawns
II for medium range of average lawns
III for low range of reasonably flat lawns .
Customer Helpline
www.gardenservicecentre.co.uk
01904 727500
7