Connection.between.remote.control.and.uav; Wifi.password.change.and.reset; Osd.language.selection - AEE CONDOR series User Manual

• Keep the working UAV away from animals, as the ultrasonic waves (not perceived by human ears) emitted
by the visual positioning system will disturb animals.
4.8 Connection between Remote Control and UAV
The remote control is already paired with the UAV. When power on the remote control and UAV, the remote
control indicates successful connection, you can use it to start the UAV.
4.9 WiFi Password Change and Reset
4.9.1 Change WiFi Password
Connect the remote control to the UAV, connect your mobile phone to the WiFi hotspot of the remote control
and start the APP. In the connection interface, tap [Settings]→[Change WiFi Password] and follow the
instructions to change the WiFi password of the remote control and UAV simultaneously.
4.9.2 Reset WiFi Password
If you've forgotten the WiFi password, reset the WiFi password to the factory default "00000000" as
described below:
(1) Reset the remote control WiFi password to the factory default: slide switch A (speed switch) quickly for
more than six times (the message "WiFi password reset successfully!" will appear on the screen of the
remote control).
(2) Reset the UAV WiFi password to the factory default: insert the test pin into the reset hole in the support
plate as shown below and press and hold it for 10s.
Note: do not change or rest the WiFi password in case of low power.
4.10 OSD Language Selection
(1) When the remote control is in power-off state, slide switch A and B to position "S" and "P" respectively
(toe-in).
(2) Press and hold the C key on the back of the holder to turn on the remote control and go to the language
selection interface.
(3) Press the record key or home point lock to select the previous or next language and then press the home
key to confirm your selection.
27
aee.com