AEE CONDOR series User Manual page 21

Toggle switch B
5
(flight mode)
6 Home point lock
7 Record key
8 Joystick A
9 Joystick B
10 Phone holder
11 Custom key
12 Hook key
13 Repeater fastener
14 Power button
15 Repeater fastener
16 Antenna
17 LED screen
18 Lanyard hole
19 Takeoff/land key
20 Follow me switch
21 Red/green/blue LED
22 Home key
23 Charging port
24 Micro USB port
25 Yaw left
26 Ascend
27 Yaw right
28 Descend
Fly left/right/
29
forward/backward
30 Power button
31 Phone holder switch
Three positions:
Position P: position mode, support spot hover with GPS or Visual
Position M: normal mode, support attitude stability augmentation, no GPS or
Visual;
Position N: neutral mode.
Press and hold it to enable/disable the home point lock function
Press it to start/stop recording the video
1 two-way joystick, support yawing and throttling
1 two-way joystick, support pitching and rolling
Place your mobile device
Trigger the remote control base calibration or remote control language
selection
Press it to open the hook and press it again to close the hook.
Note: the hook is an optional accessory.
Press it once and then long press it for 3s to power on/off the UAV
Signal transmitting/receiving antenna:
(1) 2.4G (WiFi) HD image transmission antenna
(2) 2.4G (WiFi) data transmission antenna
1 lanyard hole, hang the remote control
Press and hold it to take off or land
Push it to position ON: enable the repeater follow me function.
Push it to position OFF: disable the repeater follow me use function.
Same as the remote control battery LED
Long press it to return home. Long press it again to cancel returning.
Charge the remote control
USB firmware upgrade
Short press once and long press 3s to turn on/off the remote control
Press and hold it to open/close the phone holder
21
aee.com