Replacing The Lamp - Electrolux EBKSL4XCN User Manual

20 www.electrolux.com
Spots or discolouration of the
catalytic surface have no
effect on catalytic properties.
During the catalytic cleaning the oven
lamp is on.
1. In the main menu select the
function:Catalysis
2. Press
The display shows the time of day and the
duration of the cleaning procedure (1
hour). You cannot change the duration,
but you can delay the start of the cleaning
procedure with the function: End Time.
When the oven is at the set
temperature, the door locks.
An acoustic signal sounds after the time
ends. The appliance deactivates.
3. Touch a sensor field or open the oven
door to stop the signal.
4. Wipe the bottom of the appliance with
a soft and moist sponge.
11.4 Removing and installing the
door
You can remove the door to clean it.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the door until it is at an angle of
approximately 45°.
to confirm.
A
A
45°
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install the
door. Do the above steps in the opposite
sequence.

11.5 Replacing the lamp

Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.