Hp Trusted Platform Module - HP ProLiant DL580 Gen9 Maintenance And Service Manual

WARNING: The computer contains an internal lithium manganese dioxide, a vanadium
pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack is not
properly handled. To reduce the risk of personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60°C (140°F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
• Replace only with the spare designated for this product.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel (on page 28).
4.
Remove the SPI board (on page 30).
5.
Remove the battery.
6.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through UEFI System
Utilities.
IMPORTANT: To avoid a mismatch between boot modes, Hewlett Packard Enterprise
recommends setting system maintenance switch 7 to the same BIOS boot mode the server is
deployed in. Otherwise, the storage controller may not recognize the OS installed on the
storage media.
For more information, see "System Maintenance Switch (on page 85)."
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

HP Trusted Platform Module

The TPM is not a customer-removable part.
Removal and replacement procedures 70