Hot-Plug Drive Led Definitions; Nvme Ssd Components - HP ProLiant DL580 Gen9 Maintenance And Service Manual

Hot-plug drive LED definitions

Item LED
Locate
1
Activity ring
2
Do not remove
3
Drive status
4

NVMe SSD components

The NVMe SSD is a PCIe bus device. A device attached to a PCIe bus cannot be removed without
allowing the device and bus to complete and cease the signal/traffic flow.
CAUTION: Do not remove an NVMe SSD from the drive bay while the Do Not Remove
button LED is flashing. The Do Not Remove button LED flashes to indicate the device is still in
use. Removal of the NVMe SSD before the device has completed and ceased signal/traffic
flow can cause loss of data.
Status Definition
Solid blue The drive is being identified by a host application.
Flashing blue The drive carrier firmware is being updated or requires an
update.
Rotating green Drive activity
Off No drive activity
Solid white Do not remove the drive. Removing the drive causes one or
more of the logical drives to fail.
Off Removing the drive does not cause a logical drive to fail.
Solid green The drive is a member of one or more logical drives.
Flashing green The drive is rebuilding or performing a RAID migration, strip size
migration, capacity expansion, or logical drive extension, or is
erasing.
Flashing The drive is a member of one or more logical drives and predicts
amber/green the drive will fail.
Flashing amber The drive is not configured and predicts the drive will fail.
Solid amber The drive has failed.
Off The drive is not configured by a RAID controller.
Component identification 93