Return Of Equipment Outside North America; Equipment Handling And Storage; Marshalled Termination Assembly And Cable Installation; Marshalled Termination Assembly Installation - Siemens QUADLOG Installation And Service Instructions Manual

Installation
purchase order number for repairs. Follow the TSC specialist's recommendation for battery
connection, if applicable.
•
If applicable, you must supply a Material Safety Data Sheet (MSDS) with each item being returned if
it was stored or used in a location where hazardous materials were present.
•
Package items to be returned in their original shipping containers. Otherwise, package it for safe
shipment or contact the factory for shipping recommendations. A module must be placed inside a
static shielding bag to protect it from electrostatic discharge.
Canadian customers:
Contact Siemens Canada.
2.4.5

Return of Equipment outside North America

Contact your Siemens Representative.
2.4.6

Equipment Handling and Storage

The CAI is completely enclosed and can be safely handled without undertaking special ESD (electrostatic
discharge) handling procedures provided the bezel compartment door is closed and secured. DO NOT
touch the connector pins on the back of the module. Handle the module carefully and do not subject it to
excessive shock or vibration.
The storage temperature and humidity parameters listed in section 6 must be met for storage of a CAI.

2.5 Marshalled Termination Assembly and Cable Installation

Section 2.5.1 describes installing a Marshalled Termination Assembly to a DIN (
rail. Section 2.5.2 describes installing a Marshalled Termination Assembly to a flat surface.
Norms)
Section 2.5.3 describes connecting an Interconnect I/O Cable Assembly.
2.5.1

Marshalled Termination Assembly Installation

Marshalled Termination Assemblies snap onto DIN rails. The DIN rail types are:
•
Preferred: Top hat profile EN 50 022-35mm X 7.5mm or EN 50 022- 35mm X 15mm
•
Alternate: G-profile EN 50 035-G 32mm
To mount a Marshalled Termination Assembly to a Utility Panel or a Marshalling Utility Panel:
1. If using a factory-supplied blank Utility Panel (P/N 16114-12) or a panel that you fabricated, you
must supply and mount DIN rails and wire ducts. A Utility Panel can be mounted in a MODULPAC
2-4
SDQLCAI-1
Deutsches Industrie
May 2002