Optional (Flat Surface) Marshalled Termination Assembly Installation - Siemens QUADLOG Installation And Service Instructions Manual

SDQLCAI-1
2.5.2

Optional (Flat Surface) Marshalled Termination Assembly Installation

Removing the DIN rail mounting feet from the Marshalled Termination Assembly, in conjunction with
the installation of four mounting ears (accessory item), permits the assembly to be flat-mounted to a panel
or bulkhead. Four (P/N 16056-562) mounting ears are required per assembly as shown in Figure 2–5
(also refer to Accessories, section 5 ).
To install the Marshalled Termination Assembly on a flat surface:
1. At one end of the Marshalled Termination Assembly, remove the three end cap securing screws from
the card holder end cap. Remove and set aside the end cap.
2. Slide the DIN rail mounting feet from the grooves in the bottom of the Marshalled Termination
Assembly card holder. Discard the mounting feet. Re-install the end cap.
3. Retrieve four mounting ears and insert them in the appropriate mounting holes provided in the end
caps as illustrated in Figure 2–5.
4. Use the Marshalled Termination Assembly as a template to mark the location of the mounting ears'
holes on the surface of the panel. Typical mounting screw size is M4, or you can select another size.
After drilling or punching the holes, they should be threaded. Refer to Figure 2–3 for assembly
dimensions.
Figure 2–5 Marshalled Termination Assembly ⎯ Mounting Ear Installation
May 2002
Installation
2-9